C10FS
 |
|
10" Sliding Dual Compound Mitre Saw
- Soft start reduces noise and recoil during start-up
- 7 positive stops on bevel gauge left and right
- Electronic speed control maintains RPM while cutting
- Linear ball bearing slide system for superior accuracy
- No-load speed 3800 RPM
- Weighs 44.1 lbs.
- Includes: Vise Assembly, Slide Fence, Dust Bag, Wrench
|
|
|
|
M12V
 |
|
1/2 Inch, 3-1/4HP Router
- Plunge
- Powerful 15 AMP motor for fast, clean cuts
- Multi-slide scale and scale index system for accurate plunge
depth adjustment
- Variable electronic speed with soft start switch to prevent
torque kick-back
- Three position adjustable handles for operation comfort and
control
- Exclusive accessory pack standard
- Max. Collect Capacity of 1/2"
- No-load speed of 8,000 - 20,000 RPM
- Weighs 11.7 lbs.
- Includes: Straight Guide, Bar Holder, Feed Screw, Wing Bolts,
Template Guide, Wrench, Straight Bit, Chuck Sleeve, Template Guide Adapter, Lock Springs
|
|
|
|
DW831
 |
|
2 HP Air Compressor
- 4.0 CFM at 90 PSI
- Direct drive electric motor
- Line regulator with gauge
- O-ring on draincock makes valve easy to open and close
- Vertically stacked twin tanks, 2 gallon capacity each
- 15 AMPS and 3450 RPM
- 8.2 CFM Air displacement and recovery time of 14 seconds
- Start/Stop control of 100/125 PSI
- 4.3 gallon tank
- Weighs 60 lbs.
|
|
|
|
NT50AE
 |
|
Finish Nailer
- 18 gauge brad 3/4" to 2"
- Side load magazine and jam release
- 360 degree air deflector
- Rubber comfort grip
- Includes 1/4" plug fitting
- Nail capacity of 100
- Weighs only 3.2 lbs.
- Air consumption of .026 ft. cubed/cycle @ 100 PSI
|
|
|
|
G13SC2
 |
|
5 inch Disc Grinder
- Powerful 11 AMP motor, 2,000 max watts out
- Low-profile head permits access in tight areas
- Dust seal prevents dust from entering the ball bearing on the
commutator side
- Compact and lightweight design allows for greater mobility
- Spindle thread 5/8 -11"
- No-load speed of 10,000 RPM
- Weighs only 6.2 lbs.
|
